Heat Press Instructions
How to Apply Your DTF Transfer
What You'll Need:
- Heat press machine or household iron (household iron not recommended)
- Parchment paper or Teflon sheet
- Your DTF transfer
- Clean garment
Step-by-Step Instructions:
1. Prepare Your Workspace
- Preheat your heat press to 300°F
- If using an iron, set to high heat with NO steam
- Ensure your garment is clean and wrinkle-free
2. Position the Transfer
- Place your garment on the heat press
- Position the DTF transfer face-down on the garment
- Make sure the design is centered and straight
3. Apply Heat and Pressure
- Heat Press: Apply medium-firm pressure (60PSI recommended) for 8-10 seconds
- Household Iron: Apply firm, even pressure for 15-20 seconds, moving the iron slightly
4. Hot Peel
- Peel off the transfer film while still warm (hot peel)
- If the design doesn't release easily, reapply heat for 5 more seconds
- Tip: Use a chalk board eraser or something similar and rub firmly over transfer
5. Final Press (Optional)
- Cover the design with parchment paper
- Apply same pressure for 5-10 seconds to ensure adhesion
Care Instructions:
- Wait 24 hours before first wash
- Wash inside out in cold water
- Tumble dry on low heat or hang dry
- Do not iron directly on the design
Troubleshooting:
Design not sticking? Increase temperature or pressure time
Design cracking? Reduce temperature or time
Uneven application? Ensure even pressure across entire design
Need help? Contact us at sales@chipstees.com or 812.753.4545.